Build Tutorial

1. Lay out the entire kit for easy assembly

2. Place Viton Oring on Reservoir

3. Place reducer on reservoir

4. Loosely place clamp over reservoir assembly

5. Place reservoir heater wires the space in the reservoir clamp and tighten the clamp

6. Wrap reservoir with reservoir heater and retain with included velcro

7. Place retaining clamp on retort stand

8. Place heater assembly on retort stand and secure the retaining screw

9. Thread in quick connect fitting

10. Place the line in the fitting

11. Hook the spring hook from the wired end on to the reservoir clamp

12. Wrap the heat belt loosely around the reservoir twice

13. Run the heat belt over the retaining spring, and pull tight to secure

14. Wrap the heat belt over the line

15. Secure spring hook over syringe tip

4 thoughts on “Build Tutorial”

Daryl White
April 18, 2020

is the syringe able to be cleaned

Reply
1. admin
  May 5, 2020
  
  You can disassemble the syringe easily for cleaning
  
  TUTORIAL
  
  Reply
2. tokesly
  January 13, 2021
  
  syringe can be cleaned with 91% isopropyl alcohol
  
  Reply
admin
August 14, 2020

It sounds like your feed side fitting and valve bearing should switch places with the spring. Here is a picture of the correct order of all the dispenser components.

Reply

Leave a Reply to admin Cancel reply